Stored Image Number : The Image number for the image that will print on the header on the receipt (see Add logo to Epson TM-T88 Printer article if needed). Note : Even though the printer is connected to the network rather than directly to the register, the controlling register assigned here must still be online for the printer to print. Register : The controlling register for this printer. Backup Printer : The printer that will print this printer’s chits, in the event this printer stops working. TCP/IP Address : The IP address assigned to the printer in the Driver Configuration section above. Confirm the printer settings match the example below, selecting Epson TM U200 as the model. Receipt 1) that is going to be configured, or select Add if creating a new one. Configure the Printer in Settings Editor. Close out of the utility, and continue to Brink Software Configuration.īrink Software Configuration Settings Editor At this point, the printer should be completely configured in the utility. Ensure the printer is showing in the utility with the correct IP Address. Click the Search Button again to detect printer. Click OK when prompted for a password. Click Yes when prompted to send the configuration. Network configuration will vary, and should be determined on a case by case basis. Note : The IP Address above is for example only. Enter in the IP address, Subnet Mask, and Gateway for the printer. 
The IP Address Setting should be on Manual.
Select the printer to configure, then click Configuration.Click Ethernet on the left, then click Search.Note : If the utility is not present on the register, it can be download it from theĪdmin Portal > Help > Downloads > More downloads. Run the Printer Utility application found at: Start > Epson TMNetWinConfig.Examples of where this end can go: A wall jack, network switch, router, or firewall.Ĭomplete the following steps, for each network printer, on any one of the POS registers: Configure the Printer IP setting in the Epson TMNetWinConfig Utility.The other end of the ethernet cable should be plugged into the known working Brink network source.The back of the printer should have ethernet and power cable firmly plugged in.Estimated reading time: 5 minutes Hardware Configuration
0 kommentar(er)
